Onager
Newbie
Posts: 1
Reg: 03-19-24
|
03-20-24 02:16 PM - Post#2868154
Hello, new to the forum. I have searched the topics in 1971-1976, but don't see what pertains to my question.
I am looking to install power windows in my 1971 Impala 4 door hardtop. Is anyone aware of an after market system with motors and regulators, beyond the ones that utilize the window crank?
Would anyone have a photo or similar of what the positioning looks like for the wiring boot that feeds the wires to the rear door through the shortened 'B' pillar? I am assuming that's where the wires would run.....
|
|
 62BillT
"22nd Year" Silver Supporting Member
Posts: 6104
Loc: Moneta, VA
Reg: 09-24-01
|
03-26-24 03:42 PM - Post#2868327
In response to Onager
I don't believe you will find an aftermarket set up ready to install for your '71 4-Door anywhere out there. You will most likely have to go with good used.
Member:
-National Impala Association
-Vintage Chevrolet Club of America
|
|
Socapots
Senior Member
Posts: 440
Loc: Canada
Reg: 03-05-01
|
05-10-24 08:10 AM - Post#2869711
In response to Onager
I added power windows to my 2 dr. I was able to find everything used. I am sure there are systems you can buy but i have not looked into them. If it was a factory option i would imaging there is a plate that you would have to knock out to put the boots in. it should be pretty evident in the door jamb area where that is. This is what i did on mine.
|
|
Gain extra benefits by becoming a Supporting Member 
