Gain extra benefits by becoming a Supporting Member Click here find out how!

Classic Performance Products Classic Industries
American Auto Wire
Danchuk Catalog
Hellwig Products IncPerformance Rod & CustomNu-Relics Power Windows



Username Post: 2 dr hardtop full floor replacement
craig32 
Frequent Contributor
Posts: 1362

Age: 59
Loc: PA
Reg: 08-05-07
04-04-21 03:45 PM - Post#2817470    
    In response to Brushwolf

  • Brushwolf Said:
So welding in a ton of bracing will lock them out of position.
Thanks, Mike


Realizing this, you are way ahead of the game already. People were telling me I had to do that when I did mine (11 years ago) and I did what you are suggesting anyway. You need some flex when you set the body back down on the new floor. I used self tapping sheet metal screws to start, and when you get everything set right, start welding. I left my doors on when I did mine, I ran a brace from the wheel wells in the back to the foot braces in the front, and a cross brace in between. I raised it with two cherry pickers just high enough to get the floor in and bolt it down, then eased the body back down. ALL my floors and rockers were completely shot, only the tunnel was relatively good.
Side note: a full floor with braces should have inner rockers on it, and the full trunk floor I used had the tail pan brace on it, too.
66 Impala (almost done!)
56 Stepside shortbed
55 Bel Air sedan
81 Corvette
02 Monte Carlo (bought new)

NOTE: You are viewing an individual Post. View the Entire Topic
FusionBB
FusionBB™ Version 2.1
©2003-2006 InteractivePHP, Inc.
Execution time: 0.099 seconds.   Total Queries: 13   Zlib Compression is on.
All times are (GMT -0800) Pacific. Current time is 05:14 AM
Top