Gain extra benefits by becoming a Supporting Member Click here find out how!

Classic Performance Products Classic Industries
American Auto Wire
Danchuk Catalog
Hellwig Products IncPerformance Rod & CustomNu-Relics Power Windows



Username Post: trans/clutch noise
docjns1 
Gold Supporting Member
Posts: 86
docjns1
Loc: upstate NY
Reg: 11-12-19
04-26-20 08:44 AM - Post#2792131    

Realizing that many of us focus on those forums/threads that match what we drive, I'm reposting this from the full size forum in hopes of additional info/experience from all you 3 pedal folks...
Got my saginaw 3spd back together w/ all new bearings, tailshaft bushing, needles, blockers, clutch & pilot bushing. After half dozen short runs (about 200 miles total) I pull in driveway, throw it in N, let clutch out and it starts making a noise. Sounds like a bearing noise and is there both driving and idling in N but goes away when clutch disengaged. While driving its consistent with RPMs not road speed regardless of gear. Under car in N its very much bell hsng/front of trans. I've had it out to check input bearing and clutch, both/all seem ok....

a. cluster gear/shaft ??
b... why suddenly after driving a few runs? ( I dont beat on it, no more than 10-15mi hiway, no faster than 70)
c. upside, I'm getting real good at getting it in & out on my back!
Steve
*********
'65 Impala SS, Crocus Yellow/blk
327 / 300 L74
M11 3 on the tree
12 bolt 3.31 open dif

NOTE: You are viewing an individual Post. View the Entire Topic
FusionBB
FusionBB™ Version 2.1
©2003-2006 InteractivePHP, Inc.
Execution time: 0.103 seconds.   Total Queries: 13   Zlib Compression is on.
All times are (GMT -0800) Pacific. Current time is 09:33 AM
Top