speedbump47
Newbie
Posts: 1
Reg: 12-10-19
|
12-10-19 04:20 PM - Post#2781902
G'day,
I have a chev 305 with conventional points, new points, rotor, cap, wires, condensor, ballast resistor, plugs and coil. The motor will not start.
Spark tester on plug wire and coil wire both give spark at 4 on tester.
Ignition on, spark at points when using screwdriver to open.
By passed the ignition switch using wire coil plus to bat. No success.
Points set properly, distributor in good condition, no play at points.
Timing set correctly and plug wires in correct order.
Since I have spark and it is definitely NOT a fuel issue what can be wrong???
Thanks in advance for any ideas as I am lost at this point.
Mike
|
Gain extra benefits by becoming a Supporting Member 
