41 Years of Service

Username Post: 6568PSK kit install
docjns1 
Gold Supporting Member
Posts: 6
docjns1
Loc: upstate NY
Reg: 11-12-19
11-14-19 06:55 PM - Post#2780182    

Upon initial installation I find I need an additional bracket kit (200L) to relocate my alternator. OK, another week and $100....only to find I need to stack washers between bracket and intake to mount it. Now the kick....washers raise the bracket and rear(2nd back) intake bolt so that I cannot get my temp sender back in (which had to be removed to take out the original intake bolt)....I suppose my options are some other hokey setup or modifying a perfectly good $90 bracket???
No mention of possibly needing the bracket with kit info when ordering and the bracket seems to be a bit of overkill @ 1/4" thick plate throughout! 40 years in dealership parts biz and never seen an alternator bracket that heavy!
'65 327 stock block, heads & manifolds, LH alternator
Steve
*********
'65 Impala SS, Crocus Yellow/blk
327 / 300 L74
M11 3 on the tree
12 bolt 3.31 open dif

NOTE: You are viewing an individual Post. View the Entire Topic
FusionBB
FusionBB™ Version 2.1
©2003-2006 InteractivePHP, Inc.
Execution time: 0.088 seconds.   Total Queries: 12   Zlib Compression is on.
All times are (GMT -0800) Pacific. Current time is 07:45 AM
Top