Gain extra benefits by becoming a Supporting Member Click here find out how!

Classic Performance Products Classic Parts
American Auto Wire Classic Industries
Danchuk Catalog
Hellwig Products IncPerformance Rod & CustomJoin the Community today
Ecklers AutoMotiveNu-Relics Power Windows

Ecklers AutoMotive
Username Post: 56’ Bel Air Tranny Swap
Rick_L 
Honored Member
Posts: 27651
Rick_L
Loc: Katy, Tx, USA
Reg: 07-06-00
01-17-19 08:02 PM - Post#2757645    
    In response to CRIZROCK56

With a 265 or 57 283, you need aftermarket rear mounts that replace your stock rear mounts. A crossmember under the rear of the transmission by itself is unacceptable, it allows the engine/trans to "roll over" on the mounts too easily, as they are not far enough apart. If you wish you can run a crossmember too, but you must have the bellhousing mounts.

These mounts are attached by the transmission to engine bolts at the bellhousing.

For your starter, you need the aftermarket starter adapter plate that goes between the transmission and engine.
NOTE: You are viewing an individual Post. View the Entire Topic
FusionBB
FusionBB™ Version 2.1
©2003-2006 InteractivePHP, Inc.
Execution time: 0.071 seconds.   Total Queries: 13   Zlib Compression is on.
All times are (GMT -0800) Pacific. Current time is 01:13 AM
Top