Gain extra benefits by becoming a Supporting Member Click here find out how!
Classic Performance Products Classic Parts
American Auto Wire Classic Industries
Join the Community todayDanchuk Catalog
Hellwig Products IncPerformance Rod & CustomEcklers AutoMotive
Nu-Relics Power Windows
Impala Bob's Bob's Chevy Trucks Bob's Chevelle Parts Bob's Classic Chevy

Ecklers AutoMotive
Username Post: Bucket seat mounts/ mounting
TR56210 
Poster
Posts: 67

Reg: 10-28-18
01-07-19 11:03 PM - Post#2756844    
    In response to Rick_L

Thanks for the information and confirmation of approach. For the door side outside mounts,because of the slant of the front seat mount, I think I need to box the ends of the 1 1/2 square pipe to allow for the slant, and either weld in a bolt to allow me to then mount the pipe through the floor vertically, or mount through floor and brace accordingly under the floor.

The 1/4 inch plate on inside mounts should bring seat mounts to level. This will require shaping the floor, and possibly a reshaped divot in the floor to mount.

Thanks for mentioning the need to center the driver seat to wheel, as my initial impression was the seat was biased towards the drivers door.

Until I power the seats to hopefully lower them, my concern is adding seat height.
NOTE: You are viewing an individual Post. View the Entire Topic
FusionBB
FusionBB™ Version 2.1
©2003-2006 InteractivePHP, Inc.
Execution time: 0.101 seconds.   Total Queries: 13   Zlib Compression is on.
All times are (GMT -0800) Pacific. Current time is 04:34 PM
Top