Gain extra benefits by becoming a Supporting Member Click here find out how!
Classic Performance Products Classic Parts
American Auto Wire Classic Industries
Chevs of the 40sDanchuk Catalog
Hellwig Products IncPerformance Rod & CustomEcklers AutoMotive
Nu-Relics Power Windows
Impala Bob's Bob's Chevy Trucks Bob's Chevelle Parts Bob's Classic Chevy



Username Post: 89 Moonies to 91 Needle Gauge swap questions
Guy named Guy 
Poster
Posts: 40
Guy named Guy
Age: 28
Loc: Grand Prairie, TX
Reg: 07-31-13
10-12-18 07:56 PM - Post#2748542    
    In response to bowtie44s

Thanks Bowtie
I guess what I was using was a little to big in the first place, so I used the smallest flathead I had and got them to pop out.
The problem was I couldn't figure which hole the release tab was in. I chewed up one of the holes just a little, and didn't want to continue until I knew for sure which hole it was in. Thanks Again.

Anyway I insalled the 91 needle gauges today without the tach just for a test run to see if the speedo was even remotely accurate, and coincidentally it was spot on according to gps so I guess the truck I pulled it from at the junkyard must have had the same tire size and rear end ratio after all. However it came out of a 5-speed truck and has no PRND21 so I'll probably end up going with the other one which came from a truck I had with smaller tires and probably a 3.42 rear end. So I'll end up doing the whole dip switch thing soon and I'll let you guys know how it goes.
Thanks again someotherguy and bowtie44's

NOTE: You are viewing an individual Post. View the Entire Topic
FusionBB
FusionBB™ Version 2.1
©2003-2006 InteractivePHP, Inc.
Execution time: 0.107 seconds.   Total Queries: 13   Zlib Compression is on.
All times are (GMT -0800) Pacific. Current time is 09:13 AM
Top