Gain extra benefits by becoming a Supporting Member Click here find out how!
Classic Performance Products Classic Parts
American Auto Wire Classic Industries
Join the Community todayDanchuk Catalog
Hellwig Products IncPerformance Rod & CustomEcklers AutoMotive
Nu-Relics Power Windows
Impala Bob's Bob's Chevy Trucks Bob's Chevelle Parts Bob's Classic Chevy



Username Post: Vortec injectors
apratt89 
Poster
Posts: 42

Loc: Reno NV
Reg: 06-08-14
10-12-18 05:38 AM - Post#2748494    

Truck is a 96 k1500 4x4. I replaced the fuel pressure regulator and fuel pump. I became curious and slid one injector out of the manifold. It looked to me like the injector was at the top of the manifold. It has a little fuel hose and a connector at the injector. Well I got curious again and went to the junk hard and took another truck apart. Now the injectors were completely different. The injector was at the bottom of the injector bore and there were no wires at the injector. Mainly my question is, will that second setup work in my truck. It seems more efficient to ha e the injector down at the port rather than shooting down a hole... any education you guys can supply will be greatly appreciated.
NOTE: You are viewing an individual Post. View the Entire Topic
FusionBB
FusionBB™ Version 2.1
©2003-2006 InteractivePHP, Inc.
Execution time: 0.138 seconds.   Total Queries: 13   Zlib Compression is on.
All times are (GMT -0800) Pacific. Current time is 05:26 PM
Top