41 Years of Service

Username Post: Tublar A-Arm Torque specs
cpptech 
Classic Performance Products "Site Sponsor"
Posts: 962
cpptech
Loc: CA. USA
Reg: 12-08-06
02-14-18 02:31 PM - Post#2724410    
    In response to showvell_69

The front control arms are already lock tite and torqued on the cross shaft, do not loosen or tighten these.
The rear torque spec is same as the factory arms you could find this info in a factory service manual.
Thanks,
Aaron @ Classic Performance
800-522-5004

NOTE: You are viewing an individual Post. View the Entire Topic
FusionBB
FusionBB™ Version 2.1
©2003-2006 InteractivePHP, Inc.
Execution time: 0.061 seconds.   Total Queries: 12   Zlib Compression is on.
All times are (GMT -0800) Pacific. Current time is 03:12 AM
Top