Gain extra benefits by becoming a Supporting Member Click here find out how!

Classic Performance Products Classic Parts
American Auto Wire Classic Industries
Danchuk Catalog
Hellwig Products IncPerformance Rod & CustomNu-Relics Power Windows



Username Post: Article on converting non-posi to posi
DZAUTO 
Senior Member
Posts: 8739

Loc: Mustang, OK, USA
Reg: 12-25-99
02-01-18 06:44 PM - Post#2723035    
    In response to steelmaker

Brad,
Yes, you can use the DANA clutch pack and surface down 2 of the ~.090 plates to ~.060. Also, when built the thin plates were installed on the END of the clutch pack. If only one side of your thin plates is worn but the other side is OK, simply flip them over and re-install.

Also, here is a PDF I put together on converting a non-posi to posi center section.


NOTE: You are viewing an individual Post. View the Entire Topic
FusionBB
FusionBB™ Version 2.1
©2003-2006 InteractivePHP, Inc.
Execution time: 0.124 seconds.   Total Queries: 14   Zlib Compression is on.
All times are (GMT -0800) Pacific. Current time is 11:23 PM
Top