Gain extra benefits by becoming a Supporting Member Click here find out how!

Classic Performance Products Classic Parts
American Auto Wire Classic Industries
Danchuk Catalog
Hellwig Products IncPerformance Rod & CustomNu-Relics Power Windows





Username Post: Lower outer control arm shaft
DZAUTO 
Member #51
Posts: 8761

Loc: Mustang, OK, USA
Reg: 12-25-99
06-09-17 03:30 PM - Post#2695254    
    In response to Kori

Did you replace BOTH the shaft and the bushing?
If not, then that is your problem.
The bushing is screwed into the spindle support (upright), and if it is rusted and seized in the support------------IT CAN BE A MOTHER BEAR TO REMOVE!!!!!!!!

This is a lower-outer shaft and bushing. You can see how much the inside threads of the bushing are worn.



These three parts are the lower-outer shaft and bushing, and the upper-inner shaft.



This shows a spindle support with the bushing removed and a bushing installed.

NOTE: You are viewing an individual Post. View the Entire Topic
FusionBB
FusionBB™ Version 2.1
©2003-2006 InteractivePHP, Inc.
Execution time: 0.148 seconds.   Total Queries: 13   Zlib Compression is on.
All times are (GMT -0800) Pacific. Current time is 07:53 AM
Top