Gain extra benefits by becoming a Supporting Member Click here find out how!

Classic Performance Products Nu-Relics Power Windows
American Auto Wire Hellwig Products IncPerformance Rod & Custom
Danchuk Catalog



Username Post: 1961 Corvette
Joeyd59 
Poster
Posts: 94
Joeyd59
Age: 65
Loc: New Jersey
Reg: 02-11-12
09-20-24 08:35 AM - Post#2874030    

Need some advice.I need to reattach the body mount reinforcement plates on the rear area of a C1.These are located just ahead of the rear wheel well at that mounting point.They were riveted with steel hard rivets which obviously rusted off.Problem is they were attached BEFORE the outer body panel was attached to the inner fiberglass rocker panel and no access with cutting the area open.And of course another "Restored Car"! already painted and you know the rest.Any suggestions are welcomed BUT,I dont want to cut to body open AND No Pop Rivets!
NOTE: You are viewing an individual Post. View the Entire Topic
FusionBB
FusionBB™ Version 2.1
©2003-2006 InteractivePHP, Inc.
Execution time: 0.282 seconds.   Total Queries: 13   Zlib Compression is on.
All times are (GMT -0800) Pacific. Current time is 02:41 PM
Top