American Auto Wire
Username Post: 12V to coil when starting
Posts: 1957

Age: 68
Loc: Reidsville, NC
Reg: 09-03-06
08-11-21 05:46 PM - Post#2824959    

Hi Donny. I have an AAW system in my 55 Chevy, and love it by the way. I do have the schematics SOMEWHERE, but I moved recently and still haven't found a lot of stuff, those included. I was monitoring the 12V input to the coil and am only getting 7ish volts when cranking. If I make it 12v while cranking, it fires right up and runs fine after I remove the 12V. I think it comes from the ign terminal on the switch and not the starter but want to make sure. I may post this in the electrical section as well. Thanks in advance.

"Well my time went so quickly. I went lickety spickley out to my ol' 55"

NOTE: You are viewing an individual Post. View the Entire Topic
FusionBB™ Version 2.1
©2003-2006 InteractivePHP, Inc.
Execution time: 0.183 seconds.   Total Queries: 12   Zlib Compression is on.
All times are (GMT -0800) Pacific. Current time is 05:42 PM