Gain extra benefits by becoming a Supporting Member Click here find out how!

Classic Performance Products Classic Industries
American Auto Wire
Danchuk Catalog
Hellwig Products IncPerformance Rod & CustomNu-Relics Power Windows

Username Post: Steering column conversion
Frequent Contributor
Posts: 1424

Age: 60
Loc: Liberty, SC
Reg: 08-06-16
01-15-20 07:20 AM - Post#2784426    
    In response to Whitey409

Not that hard really. I haven't done a Impala steering column but I did the one in my 67 Ramp truck from a tilt auto column to a 4 speed in the floor. I cut the gear selector knob off grounded smooth and filled with Plumbers putty. Let it dry good for a couple of days and sand it smooth and paint. I then took the old NSS switch off and used the 2 screw holes to lock it in place with longer screws. I cut the gear selector arm off at the bottom. Painted it and installed it. Works great and you would never know it wasn't factory.
Here is my link for it.:toast:

1964 SS Impala -350 crate/powerglide
1967 Ramp truck - 350/ 4 speed
1971 C 10 - 6.0 LS / 4l80e 4:10 gears 30 years owner
94 Elderado
2000 S-10
2008 LTZ Tahoe
2011 Treverse

Edited by Andy4639 on 01-15-20 07:22 AM. Reason for edit: No reason given.
NOTE: You are viewing an individual Post. View the Entire Topic
FusionBB™ Version 2.1
©2003-2006 InteractivePHP, Inc.
Execution time: 0.084 seconds.   Total Queries: 13   Zlib Compression is on.
All times are (GMT -0800) Pacific. Current time is 12:49 AM