Gain extra benefits by becoming a Supporting Member Click here find out how!

Classic Performance Products Classic Parts
American Auto Wire Classic Industries
Danchuk Catalog
Hellwig Products IncPerformance Rod & CustomJoin the Community today
Ecklers AutoMotiveNu-Relics Power Windows



Username Post: Lifter clacking why
raceman6135 
Senior Member
Posts: 928
raceman6135
Loc: Calgary, Alberta, Canada
Reg: 11-04-02
09-12-19 04:41 PM - Post#2775413    
    In response to Jims56chevy

  • Jims56chevy Said:
Anyone come across this, With engine running and plug wire removed the lifter clacks install plug wire clack goes away.



The only time I've had something similar happen was when I wiped one lobe on a mechanical flat tappet camshaft.


  • Jims56chevy Said:
Also can you adjust hyd roller lifters with the engine running like on a flat tappet lifter? Or can it cause damage to the needle bearings?
thanks



I don't know for sure because I've only tried once to adjust a camshaft's setting while the engine was running. My hearing never was good enough (and it's worse now that I'm older) to get an accurate setting. That, plus all the oil all over the place, even with oil stopper clips and modified valve covers, etc., was enough for me to get familiar with my feeler gauges on a not running engine.
NOTE: You are viewing an individual Post. View the Entire Topic
FusionBB
FusionBB™ Version 2.1
©2003-2006 InteractivePHP, Inc.
Execution time: 0.098 seconds.   Total Queries: 13   Zlib Compression is on.
All times are (GMT -0800) Pacific. Current time is 02:09 PM
Top