Danchuk Catalog Classic Industries
American Auto Wire
Classic Performance Products
Hellwig Products IncPerformance Rod & CustomNu-Relics Power Windows




Username Post: power steering conversion
FINIS-55 
"5th Year" Silver Supporting Member
Posts: 166
FINIS-55
Reg: 03-01-13
06-22-18 12:09 PM - Post#2737923    

Hey to all, hope the weather is good for you. Been terrible here in Illinois. Bad for cruising. Anyhow I want to open a can of worms, so I am going to start with side motor mounts so I can use a manual fuel pump, then power steering and a new steering column. I have old double hump fuelie heads, so no accessories holes. Soo, new heads? See how wiggly it gets as project unfolds? If anyone has done the same and can enlighten me on this, it may help. As it stands the car is all intact and driven. So I start with the mounts which now is a Hurst saddle kit. I have an HEI ignition and no firewall clearance problems, so is the engine 3/4 inch forward with the Hurst kit or in stock position, anyone know? I notice mount kits with each position noted based on the HEI. Lets start here. Do I get the mount for the 3/4 inch forward or stock?

Edited by FINIS-55 on 06-22-18 12:21 PM. Reason for edit: No reason given.
NOTE: You are viewing an individual Post. View the Entire Topic
FusionBB
FusionBB™ Version 2.1
©2003-2006 InteractivePHP, Inc.
Execution time: 0.204 seconds.   Total Queries: 12   Zlib Compression is on.
All times are (GMT -0800) Pacific. Current time is 06:32 AM
Top