Gain extra benefits by becoming a Supporting Member Click here find out how!
Classic Performance Products Classic Parts
American Auto Wire Classic Industries
Chevs of the 40sDanchuk Catalog
Hellwig Products IncPerformance Rod & CustomEcklers AutoMotive
Nu-Relics Power Windows
Impala Bob's Bob's Chevy Trucks Bob's Chevelle Parts Bob's Classic Chevy





Username Post: 53 Chevy 210 project
postalcop 
Contributor
Posts: 144
postalcop
Loc: MO
Reg: 06-01-12
01-05-18 05:04 PM - Post#2720148    
    In response to postalcop

I started tearing apart the wire harness this week. I hurt my back on Tuesday so that really slowed me down this week. I did manage to get almost all the wire eliminated that I don't need. There are a few I want to double check before I take them off that go to the AC compressor.



This plug is inside the fuse box that sits under the hood. The ink wires are 12v+ that go to various things like the O2 sensors and injectors. The other colors go to things like relays. The big purple wire will go from the battery to the starter.



This is what I pulled out.



And this is where I am at right now. I need to wrap a few areas with electrical tape to hold it together. I will then need to get the motor mounted in the car so I can figure out how I am going to route the wires and where I will mount the PCM.

53 Chevy 210
350 engine / 350 trans
3.42 chevy s-10 rear axle

NOTE: You are viewing an individual Post. View the Entire Topic
FusionBB
FusionBB™ Version 2.1
©2003-2006 InteractivePHP, Inc.
Execution time: 0.097 seconds.   Total Queries: 13   Zlib Compression is on.
All times are (GMT -0800) Pacific. Current time is 05:54 PM
Top