Select "print" from your browser's "File" menu.

Back to Post
Username Post: 4,3 Vortec info
JFav
Newbie
Posts 1
10-10-24 02:48 PM - Post#2874561    

Im a new member to forums in general so I apologize for any dumb question or incorrect terminology ahead of time.
Im interested in using a 4.3 in an old jeep project Im about to start. My problem being I know what I would like to end up with but have limited knowledge on how to get there, especially with EFI and computers.
I would prefer to end up with a MPI 4.3 instead of TBI. I believe I would need a custom wire harness as well as a reprogramed ECU (computor). This is were the difficulty begins.
What years and vehicles would I be looking for as a donor? What all do I need from the donor vehicle? How hard will this be? Would it be better to go with the TBI version? Do I need the ECU or just look for a preprogramed ECU with the wiring harness include? I'll be mating it to a 4 SPD manual. From some of the reading Ive done I understand I wont have sensors for the ECU that it will be looking for.
Any help or direction to somewhere/someone that could help would be great.
Thanks

JFav

Shepherd
Valued Contributor
Posts 3598
10-10-24 03:49 PM - Post#2874562    

Welcome to CT. Both plans require a matching harness, a complete used engine would have all the sensors, need fuel system to the tank and the appropriate pump also. Some year ecus would have a security system programmed, so that would have to addressed. This could be a tough undertaking for a "newbie ", custom exhaust also, with an o2 sensor.
FusionBB
FusionBB™ Version 2.1
©2003-2006 InteractivePHP, Inc.
Execution time: 0.561 seconds.   Total Queries: 14   Zlib Compression is on.
All times are (GMT -0800) Pacific. Current time is 09:39 AM
Top