Select "print" from your browser's "File" menu.

Back to Post
Print Topic

Username Post: Driveshaft removal
grumpyvette
Senior Chevytalk Moderator -- Performance Subject Matter Expert --
Posts 17627
grumpyvette 		01-13-21 10:54 AM - Post#2812012    

most guys separate the yoke in the transmission as required to pull the yoke or push it into the trans to gain clearance then slide the drive shaft out
if you pull the yoke use rubber bands and a plastic glove on the trans tail shaft to limit fluid loss
in a few cases you need a bottle jack to raise the trans an inch after removing the rear trans mount bolts to gain added clearance
https://www.youtube.com/watch?v=LWimaHDMxZE

https://www.homedepot.com/p/LG-XL-Orange-Nitril e-L...

IF YOU CAN,T SMOKE THE TIRES AT WILL,FROM A 60 MPH ROLLING START YOUR ENGINE NEEDS MORE WORK!!"!
IF YOU CAN , YOU NEED BETTER TIRES AND YOUR SUSPENSION NEEDS MORE WORK!!


Print Topic

FusionBB
FusionBB™ Version 2.1
©2003-2006 InteractivePHP, Inc.
Execution time: 0.14 seconds.   Total Queries: 14   Zlib Compression is on.
All times are (GMT -0800) Pacific. Current time is 02:14 PM
Top