Select "print" from your browser's "File" menu.

Back to Post
Username Post: HEI UPGRADE
R8ROB
Poster
Posts 10
11-30-18 09:28 AM - Post#2752895    

Good morning I recently switched to hei on my 65 2dr ht. I have a pink wire that was going to the coil. Will that now be my power wire going to the HEI distributor? When key switch is in the off position it shows 1.2 VDC and when the ignition is turned on it shows 0.0 VDC on meter. I recently upgraded to AAW 510360 classic updated kit.

aawtech
American Autowire "Site Sponsor"
Posts 5150
12-02-18 11:11 PM - Post#2753144    

  • R8ROB Said:
Good morning I recently switched to hei on my 65 2dr ht. I have a pink wire that was going to the coil. Will that now be my power wire going to the HEI distributor? When key switch is in the off position it shows 1.2 VDC and when the ignition is turned on it shows 0.0 VDC on meter. I recently upgraded to AAW 510360 classic updated kit.




The pink wire in the engine harness that says 12v ignition is the feed to the "batt" on the hei distributor. Should have a a full 12 volts with the key in the "on" postion. What did you have in the car before and how did you have it hooked up?

Donny

R8ROB
Poster
Posts 10
12-18-18 02:15 PM - Post#2754940    

Looks like it wasn't fully making contact on the opposite end. that took care of the issue.
FusionBB
FusionBB™ Version 2.1
©2003-2006 InteractivePHP, Inc.
Execution time: 0.144 seconds.   Total Queries: 14   Zlib Compression is on.
All times are (GMT -0800) Pacific. Current time is 10:12 AM
Top