jz512
Forum Newbie
Posts: 49
Age: 20
Loc: Austin TX
Reg: 09-19-11
|
04-25-12 08:57 PM - Post#2219199
94 c 1500 burb 2wd 5.7v8
took off power steering pump pulley and pulley puller bolt broke of inside the shaft 
any1 have this happen to them? any way to get the bolt off...?
|
|
Allan In NE
Contributor
Posts: 903
Reg: 12-27-11
|
04-26-12 05:13 AM - Post#2219263
In response to jz512
Take a small pick and I'll just bet ya you can screw it right back outta there.
Allan
| Lifelong GM automatic transmission specialist |
|
 62chevy427
"7th Year" Silver Supporting Member
Posts: 1499
Loc: laurens sc
Reg: 04-13-06
|
04-26-12 09:57 AM - Post#2219335
In response to jz512
if the pick or center punch does not work,drill a small hole in the center of the broken part and use an ez out.
56 bel air ((since 2002)
62 impala ss (since 1965)
65 el camino (since 1969)
66 nova (since 1987)
67 malibu convertible (since 1981)
72 el camino ss454 (since 1985)
83 gmc 4wd (since 1991)
95 impala (new)
11 malibu (new) |
|
jz512
Forum Newbie
Posts: 49
Age: 20
Loc: Austin TX
Reg: 09-19-11
|
04-26-12 10:04 AM - Post#2219336
In response to 62chevy427
thanks for the advice.. i had my truck at school last night.. then that happens.. had to leave her there.. schools is in round rock im in austin.. was going to go today in the morning but have to take care of my kids 
|
|
Gain extra benefits by becoming a Supporting Member 
drtyler (4)
