Gain extra benefits by becoming a Supporting Member Click here find out how!
Classic Performance Products Classic Parts
Ciadella InteriorsAmerican Auto Wire Classic Industries
Chevs of the 40sDanchuk Catalog
Hellwig Products IncPerformance Rod & CustomEcklers AutoMotive
Nu-Relics Power Windows
Impala Bob's Bob's Chevy Trucks Bob's Chevelle Parts Bob's Classic Chevy

Username Post: Vacuum Advance- how is it supposed to work?
IgnitionMan 
Valued Contributor
Posts: 3197

Reg: 04-15-05
04-05-10 04:24 PM - Post#1893473    
    In response to Mr. Sinister

NOPE, one thing not confirmed, LIMIT THE AMOUNT OF PULL PIN TRAVEL ON THE VACUUM ADVANCE, or, there will be way too much vacuum advance timing when it is plugged into full manifold vacuum.

For a 383, 8 crankshaft degrees is all needed to supplement the initial timing, and that is limiting the pull pin to .086 of an inch travel.

If anyone wants pictures of a stop YOU can make at home, and how to measure the stop distance, send me an e/mail. Let me know which type of distributor you have, large cap HEI, or small cap points type, ask for the vacuum advance stop pics, and they will come to you at no charge, no obligation. Use this e/mail address:

info@davessmallbodyheis.com

And, the whole timing and vacuum advance dissertation above, "TIMING AND VACUUM ADVANCE 101", came from a former GM development engineer, another person who also posts here, but did not add to this topic.

Edited by IgnitionMan on 04-05-10 04:27 PM. Reason for edit: No reason given.
NOTE: You are viewing an individual Post. View the Entire Topic
FusionBB
FusionBB™ Version 2.1
©2003-2006 InteractivePHP, Inc.
Execution time: 0.244 seconds.   Total Queries: 13   Zlib Compression is on.
All times are (GMT -0800) Pacific. Current time is 08:44 AM
Top